MDT-2S demands 32 turns for full rotation.No additional elements are required to alter actuator rotation within the field. Place valve within the full open up situation with line stress shut off and zero differential pressure across the gauge valves.Get rid of 4 cap screwsand actuator cover and gasket.Eliminate and conserve grease from gear box (discard grease if new grease to become extra when reassembling).Flip shaft so that the two groove pins might be pushed out without jamming into the bottom corner in the actuator housing.Employing a smaller diameter drift punch compared to pins on their own, drive out the groove pins out with the quit collars/bearings in the contrary course from which they had been put in (pins are a bit recessed around the side the punch ought to be used on). Take note: Generate the pins out at an angle towards the bottom of the actuator housing.Get rid of the shaft by unscrewing it making use of the 2" op nut.Get rid of the lever, turn it over and location it back around the valve shaft Note: don't change the orientation in the slider nut to the shaft.To reassemble, reverse actions 1 through six. When reinstalling the 4 cap screws use Loctite to them and torque to 10 ft-lbs.Much more Information Click : valves manufacturers
RSS Feed